In 2012, Blackpool Council ordered 16 Bombardier Flexity 2 trams for the Blackpool Tramway, becoming the worldwide launch customer for Bombardier Transportation's new design.^[2] The modern 100% low-floor trams replaced the Blackpool Tramway's tourist-focused and high maintenance heritage fleet, some of which have been retained with modifications for use as a supplementary fleet alongside the Flexity 2 trams and some for tourist services on the promenade.^[2] Blackpool's Flexity 2 trams are intended to be suitable for daily commuters and to provide a service competitive with other modes of transport and comply with legislation on accessibility for disabled users.^[2][3]

Quick Facts In service, Manufacturer ...

Flexity 2 (Blackpool)
Flexity 2 tram #011 at Tower
Interior
In service	2012–present
Manufacturer	Bombardier Transportation
Built at	Bautzen, Saxony, Germany Vienna, Austria
Family name	Flexity 2
Constructed	2010–2017[1]
Entered service	3 April 2012
Number built	18
Number in service	18
Fleet numbers	001–018
Capacity	148 standing, 74 seated
Operators	Blackpool Transport
Depots	Starr Gate
Lines served	Blackpool–Fleetwood
Specifications
Car body construction	Steel side panels/Aluminium
Car length	32.23 m (105 ft 8+7⁄8 in)
Width	2.65 m (8 ft 8+3⁄8 in)
Height	3.42 m (11 ft 2+5⁄8 in)
Floor height	320 mm (12.60 in)
Low-floor	100%
Doors	8 (4 double width, 4 single width)
Articulated sections	5 (four articulations)
Wheel diameter	600–540 mm (23.62–21.26 in) (new–worn)
Maximum speed	70 km/h (43 mph)
Weight	40.9 t (40.3 long tons; 45.1 short tons) (empty) 56.7 t (55.8 long tons; 62.5 short tons) (loaded)
Axle load	9.6 t (9.4 long tons; 10.6 short tons)
Steep gradient	60‰
Traction system	IGBT–VVVF (Bombardier MITRAC 500)
Traction motors	4 × 120 kW (160 hp) liquid-cooled 3-phase AC induction motor
Power output	480 kW (640 hp)
Acceleration	0.5 m/s2 (1.1 mph/s)
Deceleration	1.2 m/s2 (2.7 mph/s) (service) 2.73 m/s2 (6.1 mph/s) (emergency)
Electric system(s)	600 V DC overhead catenary
Current collector(s)	Pantograph
UIC classification	Bo′+2′+Bo′
Bogies	Bombardier FLEXX Urban 3000
Track gauge	4 ft 8+1⁄2 in (1,435 mm) standard gauge

Close

Two further Flexity 2 units arrived on 1 and 15 December 2017, entering service on 4 March 2018.^[4][5][6]

Blackpool Council placed the £33m order for the 16 Flexity 2 trams in July 2009, with funding from the council, Department for Transport and Lancashire County Council.^[7][8] The worldwide launch of the Flexity 2 family took place with the unveiling of the first Blackpool tram on 8 September 2011.^[3] They entered service on 4 April 2012.^[2]

The Blackpool Flexity 2 trams are bi-directional five-section articulated tramcars.^[8] There are four doors on each side, two single sliding plug doors next to the driver cabs in the first and fifth cars and two double sliding plug doors in the centre of the second and fourth cars. They can accommodate wheelchairs and pushchairs,^[3] with level boarding from low platforms which were built at stops ready for the introduction of the trams.^[2]

The trams have two powered Flexx Urban 3000 bogies^[8] in the centre of the first and fifth sections and an unpowered set in the centre car where the pantograph is also located. The trams use a 600 V overhead DC power supply, can negotiate a minimum curve radius of 25 m (82 ft 0 in) in service or 20 m (65 ft 7 in) at Starr Gate Depot and can tackle a maximum gradient of 6%. Although the Flexity 2 trams family's maximum speed is 70 kilometres per hour (43 mph), the Blackpool trams are electronically limited to 50 kilometres per hour (31 mph).^{[citation needed]}

The middle and end of 2023 saw the introduction of Alstom’s collision and overspeed monitoring and prevention assistance system (COMPAS) being installed on some of the trams as part of a trial which will ultimately be implemented on all trams.^[9]

The final livery unveiled at the launch consists of white sides with black window surrounds and purple cabs, with a purple criss-cross pattern extending along the lower side panels. Some trams have advertisements on the sides instead of the average livery.

The Flexity 2 cars are maintained at a depot at Starr Gate which was purpose built by VolkerFitzpatrick,^[10] with input based on experience with tram depots elsewhere in Europe.^[2]

• Blackpool Tramway
• List of Blackpool Tramway tram stops