Video games

Older video game consoles and home computers often generated a technically compliant analog 525-line NTSC or 625-line PAL signal, but only sent one field type rather than alternating between the two. This created a 262 or 312 line progressive scan signal (with half the vertical resolution), which in theory can be decoded on any receiver that can decode normal, interlaced signals.^[2][3][4][5]

Since the shadow mask and beam width of standard CRT televisions were designed for interlaced signals, these systems produced a distinctive fixed pattern of alternating bright and dark scan lines; many emulators for older systems offer video filters to recreate this effect. With the introduction of digital video formats these low-definition modes are usually referred to as 240p and 288p (with the standard definition modes being 480i and 576i).

With the introduction of 16-bit computers in the mid-1980s, such as the Atari ST and Amiga, followed by 16-bit consoles in the late 1980s and early 1990s, like the Sega Genesis and Super NES,^[4] outputting the standard interlaced resolutions was supported for the first time, but rarely used due to heavy demands on processing power and memory. Standard resolutions also had a tendency to produce noticeable flicker at horizontal edges unless employed quite carefully, such as using anti-aliasing, which was either not available or computationally exorbitant. Thus, progressive output with half the vertical remained the primary format on most games of the fourth and fifth generation consoles (including the Sega Saturn, the Sony PlayStation and the Nintendo 64).

With the advent of sixth generation consoles and the launch of the Dreamcast, standard interlaced resolution became more common, and progressive lower resolution usage declined.

More recent game systems tend to use only properly interlaced NTSC or PAL in addition to higher resolution modes, except when running games designed for older, compatible systems in their native modes. The PlayStation 2 generates 240p/288p if a PlayStation game calls for this mode, as do many Virtual Console emulated games on the Nintendo Wii. Nintendo's official software development kit documentation for the Wii refers to 240p as 'non-interlaced mode' or 'double-strike'.^[6][7]

Shortly after the launch of the Wii Virtual Console service, many users with component video cables experienced problems displaying some Virtual Console games due to certain TV models/manufacturers not supporting 240p over a component video connection. Nintendo's solution was to implement a video mode which forces the emulator to output 480i instead of 240p,^[8] however many games released prior were never updated.^[9]