Runnymede Bridge

Runnymede Bridge is a multi-span arch bridge at the uppermost end of the Staines upon Thames and Egham Reach of the River Thames: above Penton Hook Lock and below Bell Weir Lock. It opened in 1961 to carry the A30's Staines Bypass.^[2][3]

Designs for the bridge were completed by 1939 by Sir Edwin Lutyens in concert with consulting engineer H Fitzsimons. World War II intervened, delaying construction by 20 years; Lutyens having died in 1944, his colleague George Stewart served as consulting architect, adopting the 1939 design. The bridge has a single span of 173.5 feet (52.9 m) across the Thames with 18 encased steel arches bearing the load of a concrete deck. There are two smaller spans, on land, at the abutments, taking the total length to 415 feet (126 m). As built, it had a width of 100 feet (30 m). The architectural treatment of the bridge was considered of great importance because of its proximity to Runnymede (the water-meadow) and the structure is finished with hand-made brick facings, white cement and Portland stone.^[4] Until the 2013 reconstruction of Walton Bridge, this was the first single-span bridge (i.e. without piers) over the Thames upstream, there being none in London or the estuary.^[2]

New Runnymede Bridge

New Runnymede Bridge, forming its eastern half, was designed by Ove Arup and Joanna Kennedy and built in 1978^[5] to complement the earlier western half of the crossing, also simply named Runnymede Bridge.^[2][6] It is a single arch bridge of approximately the same form, but is made up of a series of parallel concrete frames: these allow light to penetrate upwards underneath and transfer loads vertically to avoid disturbing the foundations of the westerly bridge companion. In the first decade of the 21st century, the motorway bridge was widened to five lanes each way, becoming the widest in Britain. In addition, the A30 has two lanes each way, making a total of fourteen traffic lanes, and also has a pedestrian pavement on its eastern side.